Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. Peterup

    Any Experiences In the Use of Vendor Item Control Drawing ? àà.

    I have been using Vendor Item Control Drawing (VICD) in accordance with ASME Y 14.24 for some time now to baseline commercially off the shelf (COTS) products. One of the hardest part of preparing a VICD is obtaining the tolerances for the nominal dimensions presented on the vendor’s catalog...
  2. Peterup

    Fully Employing Positional Tolerancing Over Rectangular Tolerancing?..

    Question For Dingy2 In regard to your comment of holes to lighten the part, use coordinate tolerancing. If one uses coordinate tolerancing, the plus/minus tolerance still would be required. What ever plus/minus tolerance one chose , say + .125 , you could still use GD&T tolerance method ...
  3. Peterup

    Fully Employing Positional Tolerancing Over Rectangular Tolerancing?..

    I am in the process of updating my activities’ in-house drawing standards and I would like to hear your opinions on the full use of employing geometric positional tolerancing. ASME Y 14.5 allows either rectangular coordinate system or geometric positional tolerancing method. Per ASME Y 14.5...
  4. Peterup

    Fully Employing Positional Tolerancing Over Rectangular Tolerancing?

    I am in the process of updating my activities’ in-house drawing standards and I would like to hear your opinions on the full use of employing geometric positional tolerancing. ASME Y 14.5 allows either rectangular coordinate system or geometric positional tolerancing method. Per ASME Y 14.5...
Back
Top