Search results for query: *

so... .25 min on the drawing? this way if it cuts in excess of .25, itll be ok?

oh yeah woops... ok

ok, well the plate is 1/4" thick... its somewhat square, and the cut is somewhat square as well... a fillet on the order of .100 on the inside of the lightening cut, give or take, looks ok from a design standpoint. so should i specify .12 min as the dimension? (1/8 drill) again, im after low...

I am wondering if anyone has a resource for Standard radius callouts. That is, I would like to specify a radius diameter for inside cuts of a plate for example (lightening holes) to enable the cutter to use the same drill bit for cost effectiveness. Does anyone know where can access this...