Hi,
I was wondering if anyone was familiar with a high pressure anhydrous ammonia pump. I am using this for a desuperheat configuration after gasous expansion. I am looking to go from 200 psi suction to 700 psi discharge max with a nominal flow rate of 1.5 GPM. I have looked at various...
To my suprise not too much. There are a few aftermarket options for marine applications and automotive but I am creating a custom collector with short runners to then exit straight up off the collector. After talking to a materials guy here I decided to go with 14 GA Rect. ASTM A 513 Flash In...
Hi all we are putting together some equipment packages that run off of NG Engines. We are currently not satisfied with the design of the cast iron ones currently provided to us. In I am designing a new flange/manifold for the engines. I am just curious about a few concerns. We are currently...
If you could do that it would be fantastic. I tried going to the site and downloading but my company has blocked the download page. Otherwise I'll try to get it from home.
First off I searched 3d content central and all listed websites in faq.
Hi we are putting an package together for a customer and using a standard 4.3L Chevy V-6 for the motor. We have all of our custom parts currently in Solidworks but would like to use a solid model of the engine to show our...
Hi,
We are currently putting a package together with a compressor and a gen set and want to cool both units on one cooling circuit. I'm a rusty with thermo so I thought I would turn here. Here are the specs.
Total heat load will be 150,000 BTU/hr
Ambiant temp is 100 F.
We want the coolant...
Hi, we are designing a cooling system for some various size motors, 50, 40, and 30 hp motors and was wondering about the flow we should have for our water pump. I have been trying to locate information everywhere but have been limited to almost nothing. I was trying to get a base # of some stock...
