Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Pulley Ratio
Sorry, The thread is not very concise. The 85 mm pulley would be located onto the motor drive shaft and the reduction in rpm would be required on a seperate shaft. I am trying to reduce the v-belt length required to drive the final pulley. I may well be looking to have an intermediate shaft &...- Fescue
- Post #3
- Forum: Gear and Pulley engineering
-
Pulley Ratio
Hi, can someone assist me with a basic pulley ratio setup? I have a 1500 rpm motor (shaft dia. 24 mm) and want to reduce this speed to @370 rpm. My question is: If I add an 85 mm pulley onto the drive shaft of the motor will this reduce the rotation by 1:3.5 before I look at the end drive...- Fescue
- Thread
- Replies: 3
- Forum: Gear and Pulley engineering
