Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Need advise on creating a time study/work measurement
get a stop watch or two, and make a list of possible things each employee could, should, and shouldnt be doing. Every minute or two, look up, spot check the employees and put a quick check by the category that best fits what their doing.... Go back and do the analysis and if your sample size is...- gth835x
- Post #7
- Forum: Industrial/Mfg engineering general discussion
-
Press Fit Pin, Ballout of 2 Ends using 1 Hyd. 100 Ton Press
The troubleshooting part of this is as follows: How do you "ball-out" the ends of a 1/2" x 3 1/2" st. steel pin using a 100 Ton Hydraulic Press. The procedure as is: Place the Hub over one end of the shaft, drill a hole through both then put the pin in. To ball out the ends we are...- gth835x
- Thread
- Replies: 4
- Forum: Steel and Stainless engineering
