Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
sheet metal dimple
Tom, SE does not allow you to create a dimple with different depths. You will have to switch to part evnironment to create it by part features. Chen- chenwei
- Post #2
- Forum: Siemens: Solid Edge
-
SE Books
Solid Edge V18 for Designers (Paperback) by Sham Tickoo- chenwei
- Post #2
- Forum: Siemens: Solid Edge
-
Roller Die, Flat Pattern
Hello, If you use SE V18 or later, you can Wrapup the Sketch to the cylinder surface, then make the boss with "Normal Protrusion" command. Then you can taper it by Chamfer command with 2-setback option. The workflow is much easier than using the swept protrusion. I've attached bitmap of the...- chenwei
- Post #8
- Forum: Siemens: Solid Edge
-
save as flat....(DXF) is producing an empty file
Hi, You can't save a sheet metal part as a DXF file. Check File/Save As you will see Save As Type doesn't provide dxf. I guess you perhaps intended to save the Flat Pattern as DXF, which matches File/Save as Flat. If so, you would need to call function SaveAsFlatDXF, which is a member of...- chenwei
- Post #2
- Forum: Siemens: Solid Edge
