Thanks for the posts......I have done this by using the mass properties in Solidworks but I was just trying to get this done in MathCAD. I will just be simple in my approch to this and use Solidworks
I am trying to calculate the moment of inertia for a 'sector of hollow circle'. I have found the formula in Roarks formulas for stress and strain page 808. This formula works out but my problem has parallel slots(which do not pass through the centerline)that are 0.188" either side. Can anyone...
I am intrested in the padeye thickness as I have a spreadsheet that gives the padeye thickness for the following shackles:
1-1/2", 17 tonne Working load limit shackle as 59mm thick
1-1/8", 9-1/2 tonne Working load limit shackle as 45mm thick
1", 8-1/2" tonne Working load limit shackle as 41mm...
I am looking to find information regading sea fasteners to hold down deck equipment on a vessel. Typical fasteners are cleats that are welded to the deck and held into ISO pockts or forklift pockets. I am new to this and really looking for more information that is available and q am also...
