Hello All;
Would anyone know the best way to verify shaft
rotation when this furnace is in operation? If the
belts brake on the 1 15/16 dia fan shaft the load is
scrap. I need some kind of warning system for the
operator. I was considering a two piece shaft collar...
Hello;
Does anyone know of an epoxy or compound of paint
which I can coat the inside of some new process water tanks
we are building. The water will be as high as 180 degrees F. and will have an alkali chemical mixture of about 13 OZ/GAL. This will be a 6 stage degrease operation with...
Great NEWS;
I was able to install the hydraulic unit with
both pumps under their own three way sol valve. At a
flow rate of 2.5 GPM the flow controls were almost
all the way closed but RPM was dropped to 18 for each
motor. Both are run at the same time during...
Hello All! Havn't given up just didn't know that there would be such a great response for this problem.
The pump is rated at 3000 Psi at 2.5 gpm. I will have
to use the flow controls to slow the tables down to around
25 RPM. Both pumps are under water on a framework with
sealed roller...
Hello;
Thanks for the reply. I called the motor manufacturer this morning and he guaranteed that the
motors could be hooked up in series and operate off
one motorspool control valve with flow controls on
ports a and b. He said that that's the way car wash
brush systems are set...
Thanks for the reply. I have decided to buy larger
motors at 24 ci/rev each and live with about 30 Rpm.
These tables are 36 inches in diameter and the parts
are evenly distributed for spray washing at 2000 psi
130 degree water. The most economic way to run might
be two separate...
Hello; I need to rotate two tables with hydraulic motors 6rpm each. Motor volume 12in3/rev each. Pressure
at least 1200 psi. Tables are under water at 180 deg f
and are loaded with 1200 pounds above the water level.
Could I use one three way motor spooled valve and
hook up both motors in...
