Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. solidNeutron

    An anti-backlash gear with module 3

    I am working on a design requiring zero backlash in my set-up. I have an anti-backlash gear that rotates an absolute encoder. This anti-backlash gear should have module = 3 and 120 pitch diameter. I haven’t had luck finding an anti-backlash gear with that module. All anti-backlash gears I’ve...
  2. solidNeutron

    Cutting holes in a cavity

    Thanks guys. I'll use a couple of dowel pins and tap the other holes as GageDr suggested. Cheers, solidNeutron
  3. solidNeutron

    Cutting holes in a cavity

    Thanks desertfox. I appreciate it. solidNeutron
  4. solidNeutron

    Cutting holes in a cavity

    Hi desertfox. The holes should be within 50 microns. I also might have some holes for dowel pins. The cavity is relatively small, 150x250x150 mm deep. Regards, solidNeutron
  5. solidNeutron

    Cutting holes in a cavity

    Image shows a simplified version of my part. It is a stainless steel block made of 10 mm plate filled with lead. There is a cavity in the block 150x250x150 deep with 6xM10 holes in the bottom side. These holes have to be cut quite accurately because they are used to mount some precision...
Back
Top