Search results for query: *

The lining is cement - have you ever done this before?

Our company lines pipe and it gets spinned to the inside of the pipe including the bell end of the pipe - does anyone know of a way to seal off the bell end of pipe so that does not occur?

Where I work, we coat pipe all the way down and then remove the last 6 or so inches of coating after it was coated. This is done on an assembly line fashion and the coating is applied while the pipe spins and the coating gets thrown against the inside of the pipe usng centrifigal force. What...

we are looking for a pipe stop which will stop pipe rolling down a rail. This pipe stop will have to move out of the way for th epipe to roll by after rail is full - anyone out ther use anything

we are making a casting - and purge the ladle with pure nitrogen - looking at using a membrane system with liquid backup to save money - what issues will I have if I use a lower purity nitrogen?

purge out the impurties - balance oxygem argon etc

Can you purge molton iron with 99.9 % nitrogen in place of 100 % nitrogen?

Yes, I could do non contact but will it handle th temperature?

can you purge molton iron with 99.9% nitrogen without getting impurities - looking at getting an onsite system to be main supply with liquid nitrogen tank as backup?

Does anyone know of a cheap vibration instrument which can take readings, then download to computer for analysis? JOhn

I run round stock in various diameters going through the oven horizontally rolling down being pushed by a chain conveyor with peridic ss rods that stick up into the furnace and when then rolling stock runs over it, it depreeses the rod and activates the switch. That is way it is suppose to work...