Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Tail and Intermediate shaft coupling bolts
Dear Mike, According maker the fit is an interefernce fit. So I found the intereference fit standard values from ANSI which are different than the drawing values. Also maker measurements are within the standard but when we receive the shafts and bolts and we carried out our measurements we...- vs1973
- Post #3
- Forum: Marine/Ocean engineering other topics
-
Tail and Intermediate shaft coupling bolts
Hello All, I would like your advice. What is the tolerance of fit between bolt and hole (dia:48mm) for flange coupling between tail and intermediate shaft? I've checked the drawings and ANSI and I found differnet values. Is it permited for cooling fitted bolts to be smaller 1/100mm from the...- vs1973
- Thread
- Replies: 4
- Forum: Marine/Ocean engineering other topics
-
INTERFERENCE FIT OF COUPLING BOLTS
Hello All, I would like your advice. What is the tolerance of fit between bolt and hole (dia:48mm) for flange coupling between tail and intermediate shaft? I've checked the drawings and ANSI and I found differnet values. Is it permited for cooling fitted bolts to be smaller 1/100mm from the...- vs1973
- Thread
- Replies: 1
- Forum: Welding, Bonding & Fastener engineering
