Hello,
I am trying to find out how to check if there will be a reverse in flow of two gravity feed tanks that flow in series with the entry and exit being submerged. Can I just use the Bernoulli equation? Or do I just ensure that the outlet pressure is smaller than the inlet inlet (hydrostatic...
Hello
Can anyone possible tell me the concentrations needed to cause chemical burns of the skin from sulphuric acid, hydrochloric acid, and caustic?
Thanks in advance
Cotter
MJCronin.
Hi I had do a very similiar calculation. I based it on this reference on the net
http://users.rcn.com/shanahan.ma.ultranet/TempModeling.pdf
plus a few basic heat transfer properties. Such as enthalpy in of incoming stream and outlet streams. While this assumes steady state and good...
Hello all
Does anyone know where I would be able to find the maximum heat flux for metals. In particular stainless steel and carbon steel. Also some typical heat fluxes for evaporation.
I have done a heat loss calculator for tanks, thickeners and pipes, but want to ensure that I am within the...
I am trying to calculate the heat loss over a CCD. It has an open top and a cone bottom (off ground). How to I find the convective losses (natural convection) from the bottom of the tank. Can I assume it is the same as a horizontal surface? (I have done a calcutaion for closed tanks with conical...
I need some help locating how to design a ring air sparger (perforated pipe). I have already looked at Perry's but need sometning a little more in depth including pressure drops over the individual orifices, velocities through the orfices, optimum holes etc.
A good book or refence would be...
