Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. jcromwell

    Non mercury sealed A/C motor contactors

    We are looking for a solution for contactor failure in a highly contaminated environment. Mercury displacement contactors are not an option. The majority of sealed A/C motor contactors in this category seem to be for the aerospace and military. Highly specialized products for these industries...
  2. jcromwell

    Grounded L1 leg?

    A bit? A lot. I am in the process of upgrading and retrofiting the facility, it is unbelievable that this place has not been shut down or someone has not been killed. I have rectified several dangerous situations and will continue to do so as budget and time permits. This process will take a...
  3. jcromwell

    Grounded L1 leg?

    Presto I am must be tired the reading was .4 Ohms if I had an A/C HI-POT I would have found it, just kidding it was my to many years of working on above ground circuitry using ground relay detection and protection were you will never encounter a low megger or Ohm reading from any circuit or load...
  4. jcromwell

    Grounded L1 leg?

    There are many things in this facility that are not to code or even industry accepted practices. I am trying to put out one fire at a time. I have not powered this machine back up yet. I was looking for some clarity of what I was seeing. However I belive you have explained what I was seeing. My...
  5. jcromwell

    Grounded L1 leg?

    Ok here it goes we have a 3 phase machine that uses 4 three phase motors and one single phase motor. There was a short in the receptacle that caused a phase to ground short after replacing the receptacle, I megged the motors and checked each power phase from the contactor to ground. I had a zero...
  6. jcromwell

    Grounded L1 leg?

    Ok here it goes we have a 3 phase machine that uses 4 three phase motors and one single phase motor there was a short in the receptacle that caused a phase to ground short after replacing the receptecle I megged the motors and checked each power phase from the contactor to ground I had a zero...
  7. jcromwell

    SMC ECC50 CYLINDER CONTROLLER

    I am upgrading some manufacturing equipment from the dark ages currently running SMC ECC50 cylinder controllers and cannot find any documentation on these plc's internet searches have turned up zero information other than they are older than dirt I would be happy to pay for any documentation.

Part and Inventory Search