kellnerp,
That is a very good idea to do the SW Modeling challenge, I will look into that. But it is hard cause all I have is just teh evalution edtion of 2009 and it is just about to expire. I dont have $5000 to go spend on SW2010.
MechEng2005,
I am trying to use other programs but how do u...
What I do for hoses and wires is I make a rigid right angles 3D sketch than i fully constrain it than add fillets than use the sweep on the circle.
T.C.Thornberry
Mechanical Designer/Drafter
I only have about 20 months of on job experience that is about 3200+ hours. But have used Solidworks for 3.5 years:
At home with student and evaluation editions.
At school.
And on the job.
I am in the process of trying to get my CSWP to find a job. How much is a CSWP worth in the eyes of a...
I had an issue to with part 3 of the CSWP. I called my service rep. and he said that not many people have been complaining about this issue. But he did mention this, sometimes the values of the Evaluation copy the materails are set to 3 decimal places(.XXX) not 4 like they say in the question...
I am looking to seal a face as shown below
Load Rotating axis Load
_______________________________________________
| Seal | | Seal
___\_/___ | ___\_/___
||||||||||||| | ||||||||||||||||
___/ \___ | ___/ \___...