Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. zuluyankee

    ABAQUS ERROR: An attempt to access admc buffer

    Does anyone have any experience with the following error when submitting a abaqus job to the cluster, specifically when using cohesion surface interfaces? “ERROR: An attempt to access admc buffer (fileId =0, pkgId =16, recordId =1381, bufferId =2) has failed.”
  2. zuluyankee

    ABAQUS ERROR: An attempt to access admc buffer

    Does anyone have any experience with the following error when submitting a abaqus job to the cluster, specifically when using cohesion surface interfaces? “ERROR: An attempt to access admc buffer (fileId =0, pkgId =16, recordId =1381, bufferId =2) has failed.”
  3. zuluyankee

    mapping & interpolating loads from table into patran

    thread824-106551 I have a table of points(xy) and corresponding loads. I am looking for suggestions on mapping subject data to structural model in patran
  4. zuluyankee

    bending / shaping 7075-T73 extusion

    This question is primarily for aerospace metal material and process engineers I have a 7075-T73 extrusion. L angle, .2 thick, 1.5" flange, 5ft length. 1) The last 24" I need to arc/bend the extrusion to approx 2.5" up from center line. 2) The last 24" I also need to bend out the lower flange...

Part and Inventory Search

Back
Top