Hello Hudson,
I used positioning constraint in my assembly and it works perfectly. The problem I had regarding not being able to deform the spring during the animation was that I defined the spring to be deformed in a specific range in the third step of defining the deformable part.
Thanks to...
Hi,
As Hudson888 said above, yes it is possible although I am not able to animate the compression of the spring in motion animation despite the fact that Hudson and Doc explained it.
I can deform the spring in the assembly by going to Assembly--component-- deform part, but not the way you...
Thank you Hudson,
I am, however, still not able to succeed in animating the deformation. I can rotate the rocker and move the seat in your animation set up, but can not deform the spring even though I can see in assembly that you defined the spring as deformable.
Hudson,
Could it be too much...
Hi,
I am trying to simulate the motion of some components in an assembly. The assembly includes a spring as well.
Is it possible to simulate the compression of the spring in motion simulation.
Looking forward to any input in this regard
nkwheelguy
It is actually a text that troubles me. Everytime I use the symbols, there comes a default text with it and then I need to delete it. Please see attatchment.http://files.engineering.com/getfile.aspx?folder=6227b271-0873-49a8-a2eb-fa4fa18b013e&file=UG_Question.doc
Hi,
Is it possible to edit custom symbols? If yes, how?
I can only see create custom symbols in:
file-Utilities- create custom symbols
I appreciate your help in advance.
Regards
I am quite new in unigraphics and I use NX5.
I would like to create animation of a simple assembly consisting of a shaft and a wheel which is turning. I have difficulty defining a trajectory curve and key frems.
Can anyone help me by writing the steps to follow in order to create animation