hi all,
new to pro e and have it set up on my laptop got a few problems
when I go to select a line in pro e I have to move the mouse for it to become highlighted i.e when I click the line I then have to click and drag the middle mouse button for it to turn red
also when I go to help and click...
only did Solids 1 in university remember seeing the picture of the chain hook in the book subjected to loading which is what you are on about I think, now to complicate things if these 3 loads were at 118, 123, 119 respectively do the arc angles just change
have a circular plastic sheath that I am compressing at 3 points 120 degrees apart, sheath outer diameter 0.070in, inner diameter 0.040in, trying to figure out how I can calculate the displacement using equations, any bright ideas other than FEA analysis.
regards,
aidank
have a circular plastic sheath that I am compressing at 3 points 120 degrees apart, sheath outer diameter 0.070in, inner diameter 0.040in, trying to figure out how I can calculate the displacement, any bright ideas other than FEA analysis.
regards,
aidank
hi,
looking for some guidance/opinions/experience on hydrostaic wheel loaders sub 100hp.
It seems that nearly all the new wheel loaders sub 100hp less than 10yrs old have a hyrostatic drive rather than the conventional torque. I have been told that this hydrostaic drive is not as robust as the...
sorry forgot the link
http://cgi.ebay.com/3-spool-mono-block-directional-valve-Brand-Hydraulic-CO_W0QQitemZ320281435214QQihZ011QQcategoryZ57011QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
hi all new here so here goes hope I am posting in the right place,
have just bought a 15 yr old jcb loading shovel with 4 ordinary manual type spool valves on it, something like this to operate the different hydraulic functions
I am wondering would it be possible to convert these into a servo...
