Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
oven cured fiberglass?
to limit warping you should balance your laminate stacking and could also consider non crimp fabric (stitched fabric rather than woven, or satin weave rather than plain weave) Other than than any resin can be post cured in an oven. You should refer to the manufacturer for the best post-cure...- QuentinNZ
- Post #7
- Forum: Composite engineering
-
Cutting thick carbon fibre sheet
You could try water cutting with a high pressure jet. Should be able to work with 10mm thickness. The cut will also have a much higher accuracy than using a band saw.- QuentinNZ
- Post #3
- Forum: Composite engineering
-
Goodness of fit coefficient
Hi, I am trying to fit one experimental data curve using a power law fitting. To make my fit ting curve closer to the experimental one I have taken three overlapping interval on wich I fit a power law. My calculated curve is so made of three parts and I am trying to optimise the transition...- QuentinNZ
- Thread
- Replies: 7
- Forum: -Engineering spreadsheets
