Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Bearing fully submerged in hydraulic oil
Thanks for all of the replies... After looking over the thread again, I realized that I gave the wrong size for the bearing. It is actually a 35mm bore, 80mm OD, and 21mm width. Basically the equivalent size of a 6307 bearing, except that it is a cylindrical roller bearing right now...- MSoap
- Post #11
- Forum: Bearing design, manufacture and maintenance
-
Bearing fully submerged in hydraulic oil
The bearing has a ID of 2.25" and an OD of 3", with a width of 0.375" wide.- MSoap
- Post #3
- Forum: Bearing design, manufacture and maintenance
-
Bearing fully submerged in hydraulic oil
I was wondering if anybody might have any comments on the possibility of using a cylindrical roller bearing which is completely submerged in a hydraulic oil bath. The bearing will be used on a test stand, where the inside of the bearing housing will have a circulating oil bath, which will be...- MSoap
- Thread
- Replies: 11
- Forum: Bearing design, manufacture and maintenance
