Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Contact Element Problem
Yeh, I tried that too - didn't work- Edge13
- Post #6
- Forum: DASSAULT: SOLIDWORKS Simulation/FEA
-
Contact Element Problem
No, the hole was in the middle of the part- Edge13
- Post #4
- Forum: DASSAULT: SOLIDWORKS Simulation/FEA
-
Contact Element Problem
OK, folks I figured it out, and maybe the solution will help some of you. The contact sets were between sliding members, a plate and a nylon slide pad. Although the analysis was static, I put the contact sets in so the program would not generate tensile reaction forces between two contacting...- Edge13
- Post #2
- Forum: DASSAULT: SOLIDWORKS Simulation/FEA
-
Contact Element Problem
Running Cosmos 2008 on a relatively complex assy with 64 no penetration contact sets. Have run before with no problem. After making some unrelated modifications to the structure, the model will mesh but not run, citing "Improper or no target define (sic) for contact element xxxxxxx". All contact...- Edge13
- Thread
- Replies: 5
- Forum: DASSAULT: SOLIDWORKS Simulation/FEA
