I'm so sorry all. I was bit busy and didn't have the chance to post the name plate of the 2 motors.
It's GUSHER pump.
Model : 11201-XLONG
Serial : 1203-260
Volts: 230-460
AMP: 1.6 - 8
HP: 1/2
RPM: 3450
CY: 60
Ref: 34G61 - 3229S2
IMP 2281 - B
I just checked the amprage of the wires using clamp...
I just replaced same type of motor, same serial #, RPM, HP, everything the same. I got this motor from the manufacture.Before I diconnect the wires, I even wrote down the connections as low voltage connections.I connected the same wire connections on this new motor. It runs for about 15-20 min...
I guess I posted my thread in the wrong forum and then my thread got deleted. I was just hoping that instead of deleting my thread the mod could have move the thread to the right section of the forum, because I guess a lot of us here sometimes missed read, time consuming, not knowing, etc...
I took them apart, cleaned inside housing using electrical contact cleaners, sand the all electrical contacts, checked all connections. Put back everything, power it up, voila......this time it spins as soon as I turn ON the switch. :)
Once again thanks fr the tips Waross.
By the way...
Thanks for the tips.
I checked the switch when turn ON, yes there's current.
Dissembled the motor and cleaned inside. Yes I see some corrosions. I used air gun to blow it out. Put back everything, still the same results. Humming and vibrating.
I still hear the click
Do you know the place or...
Hi All,
I'm trying to figure out why the ac motor that I'm working on is giving a humming sound, vibrations when I turn ON the power switch. I have to give it a kick or a pushing turn to help then it runs fine. When I turn the switch to OFF position and when it stops spinning, I can hear the...
