Search results for query: *

I currently have a template that consists of 2 sheets, each with a different format applied. Whenever a new sheet is added it automatically inserts the template from the first sheet. I know how to go to page setup and change that but I was wondering if there was a way of changing it so that...

Hi I am learning how to use Pro E drawings and have come across something I can't find an answer for. What I have is a model that has many different configurations that are set up with simplified reps. What I want to do is have one set of drawings for each. What I can't figure out how to do...

Hello, I have a very generic problem of a cantilever beam with a load at the end and am trying to calculate the critical load. I have calculated the critical load to be about 32,000 psi. When I run the analysis through Pro E Mechanica, the first buckling mode is supposed to occur at about...

All good suggestions on how to change the legend, but not quite what I'm asking. I am wondering how to change the number of significant figures that are shown on the legend in the results window.

Thanks for the help guys....I think I have a better understanding of the difference between the two.

Hi, I am currently being trained on the job in FEA and ran into a problem. I was wondering what the difference between the grid that you set when setting up the analysis and the mesh for a computer model. I always thought the mesh determined the nodes that the values were calculated at but...

Hi, I am currently being trained on the job in FEA and ran into a problem. I was wondering what the difference between the grid that you set when setting up the analysis and the mesh. I always thought the mesh determined the nodes that the values were calculated at but was told here that the...

Does anyone know if it is possible to change the number of significant digits of the legend when viewing the fringe plots? Thank you very much in advance for any help you can provide me with.

Teguci.......I tried it your method and got the same answers you did. I have also ran this through Pro/E Mechanica to compare the answers. I know I won't get the exact answers but I was wondering, generally, how much error is acceptable. In this case Mechanica found a 0.155" deflection and a...

Does anyone know if it is possible to change the number of significant digits of the legend when viewing the fringe plots? Thank you very much in advance for any help you can provide me with.

This is a small sheet metal support made out of Al 6061-0 that is 0.045 inches thick throughout. There is a load that is evenly distributed on the top surface totaling 50 pounds. The bottom of the two supports are resting on a firm surface. The part is 1 inch high...from the bottom surface of...

Hi, I'm an Entry Level engineer fresh out of college. I'm still having problems learning how to apply the basics to real world problems because they did not do a good job teaching us that in school. I was hoping someone could tell me how I go about solving the problem below by using hand...