Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
License Request Failure
Hi, I recently had a health check done on my PC, and since then when I load ProEngineer it comes up with a Warning License Request Failure - Invalid Host (See attached image). The software does not load. I am using Wildfire 4, I don't use the software often and I am not on support...so can...- Klaxon1
- Thread
- Replies: 2
- Forum: PTC: Creo Parametric (Pro/ENGINEER)
-
Snap Fit Calculations
Hi, I have been looking into snap fit clips on plastic parts, and have been fine so far working with strieght and tapered beams. I am now trying to work out an 'L' shape clip, but the only formula I have found is confusing. I have attached it to this thread. I have no problem filling in the...- Klaxon1
- Thread
- Replies: 2
- Forum: Mechanical engineering general discussion
