Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Spline Load Capacity
I have a copy of DIN 5466-1 2000-10 which I am trying to use to rate some splines. There are some undefined parameters (stress concentration factors and size factors etc) used in the calculations. There is a note given for these parameters that I have transalated as "Standard in Preparation"...- phtmh2
- Thread
- Replies: 1
- Forum: Mechanical engineering general discussion
-
Dynamic Reduction
Hi, I'm trying to perform a dynamic reduction to reduce a rotating shaft. So far I have been able to produce the stiffness and mass but not the damping (gyroscopic) matrix. I have applied a rotating velocity around the axis of the shaft and then performed a CMS analysis but this has only...- phtmh2
- Thread
- Replies: 0
- Forum: Siemens: Femap
