Good afternoon,
I want to create a viscoelastic material in Abaqus 6.9-2 CAE. Therefore I need to create a material in terms of density, elastic information (Young's modulus and Poisson's ratio) and viscoelastic information (In this case: Prony series). In the viscoelastic information section...
To be clear:
I don't know where to put the G0 from the Prony series.
I'd like to create a viscoelastic material using Prony series. In the Abaqus 6.9-2 CAE manual I found I have to define a viscoelastic material by the next material behaviours:
1. Density: Density
2. Elastic: Young's modulus...
Hello again. Thank you for your response.
I have the Prony series now in term of G0, g1 to g5 and tau1 to tau5. Now I'm confused what to do with the G0 term? I cannot put in the viscoelastic data table, since it starts with g1. I used the definition of the Prony series from the Abaqus manual...
I'd like to use the Williams-Landel-Ferry equation to create a mastercurve.
I'd like to have a frequency range of 1 to 1000Hz at 23 degrees. The DMA machine has a frequency range of 1 to 200Hz. Therefore, I did a temperature sweep from 23 to 140 degrees Celsius. I think I made an error here. I...
I'd like to model a viscoelastic material in Prony series terms in Abaqus 6.9-2.
I have DMA measurements (shear loss and shear storage moduli vs frequency) for various viscoelastic materials in terms of frequency Prony series, so g_i's and tau_i's.
In Abaqus, I create a material in terms of...
I'd like to model a viscoelastic material in Prony series terms in Abaqus 6.9-2.
I have DMA measurements (shear loss and shear storage moduli vs frequency) for various viscoelastic materials in terms of frequency Prony series, so g_i's and tau_i's.
In Abaqus, I create a material in terms of...
SolidWorks interprets the dimensions in the *.sat right, so I think the problem isn't there. In Abaqus the units cannot be found; it seems like input units are output units. Without scaling factor the beam length is 72 (no units) instead of 0.072 (scaled).
Anyway, thanks for your response.
Hello all,
When I import a part into a *.sat (ACIS SAT) file into ABAQUS CAE 6.9-2, I need to scale the part by 1e-3. Why? mm to m?
The ACIS file was drawn in SolidWorks. In SolidWorks, when I change units to meters instead of millimeters, I still need to scale the model by 1e-3 when...
