Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. khalil1

    Shaft Hardening

    Thank you CoryPad, Your advice was realy helpful.
  2. khalil1

    Shaft Hardening

    will it be any issue for machinning process after we do our quench & tempering process or not? please advise. Thank you
  3. khalil1

    Shaft Hardening

    Just I am wondering if we go for Q&T process with recomended alloy(1040,4140,...), doesn'it affect our machining process?( which needs to be done after Q&T application).
  4. khalil1

    Shaft Hardening

    Yes, Exactly it is a plastic deformation and it is hapening after dynamic application.So if it is the case if there is any substitude material with higher TS and suitable for machinning?
  5. khalil1

    Shaft Hardening

    Hi There, I recently joint the group and I came up with following issue which very much related to material selection and applying the right heat treatment. we are using A.I.S.I 1144 steel for our starter armature shaft (.8225/.8240')and carburising the full length of spline to R/C 48/55 (depth...
Back
Top