Hi all,
I have a big problem in my life, that is procrastination. I spend too much time Internet surfing specially at work. Most of my working hours are spent surfing webcam sites. I decided too many times to relieve myself from this bad habit but no success. I always say I will start from...
Dendrobium 1975,
It depends on the function of the heater. is it a cracking/reaction furnace? or a simple heater for warm up?
I think you should set the TWT for the lowest one between design temperature and creep temperature (if you have free carbon in the coils).
I am involved in calculation of NGL quantity we import to storage tanks on daily basis. For this calculation, a turbine type flow meter/ counter is used. we do temperature and pressure correction (calculate CTL and CPL) by using API MPMS standard section 11.1.
But I am in doubt which tables...
The index of valve shows that it is open but we are not sure. How to verify? If the screen is covered with debris how to clean it without stopping the turbine?
thanks to all. I copied this post to "engine& turbine engineering forum". Please reply there.
JJPelin & Dcasto
we are sure that all manual valves are open. the governor valve is open and working correctly. throttle valve is located before governor valve. as i said before, the problem is high...
Hi,
Recently we have faced a problem in operation of our ethylene refrigerant compressor. Although the compressor is working below full capacity, turbine governor valve is fully opened but steam flow is 18 ton/hr compared to full load steam consumption of 30 ton/hr. we have washed the blades and...
Hi,
Recently we have faced a problem in operation of our ethylene refrigerant compressor. Although the compressor is working below full capacity, turbine governor valve is fully opened but steam flow is 18 ton/hr compared to full load steam consumption of 30 ton/hr. we have washed the blades and...