Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
TP and FCF basics
caseynick, you give me useful information, but as far as the height value included in the calculation, (z axis per se) when this TP is called out, is the third axis a factor? Do I only inspect/report values of TP based on Basic callouts, or do I include deviatons in the z axis. In other words...- kasabis
- Post #4
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
TP and FCF basics
looking in the asme y14.5 1994 pg 53 i see that all TP callouts must have a basic dimension locating these features. If this is true and i am inspecting the part from the example shown, would I have to include the height at which it was measured to have a 3D TP calculation (XYZ), or am I safe in...- kasabis
- Thread
- Replies: 20
- Forum: Drafting Standards, GD&T & Tolerance Analysis
