What was the actual pressure when you started the turbine? If the pressure is too high or if you tried to start the turbine before it vacuumed down, you will have this problem. The turbine should only be run between ~60 and ~140 Kpa
Are your 3 laser gasses correct? if you have N2 or CO2 where...
Rana- you can use another vfd, like a delta C2000 but you'll have to configure it.
If the vfd is outputting 370hz, the rpm will be correct.
You can find those connectors in the schematic, there's a reset signal, a run signal, and a 120hz signal to break in the bearings.
If the blower is...
Darren- Are the fans running on your chiller?
Rana- what VFD did yo have originally and what resonator do you want to use it in?
Chris Krug http://krugtech.com/
Maximum Up-time, Minimum BS
You have to hit shiftlock and F1 while in the menu that shows the drives at the top of the screen and reconfigure the drive list. I have a lot of CNC90/dosbox experience. Feel free to call or txt 706-627-7854
Chris Krug http://krugtech.com/
Maximum Up-time, Minimum BS
Removing the tube between the output window and shutter usually resets it. They want to see that someone took the tube out to look at the optic. Call or txt me 706-627-7854 for help. Did you look at the actual temperature of the optics while cutting?
Chris Krug http://krugtech.com/
Maximum...
It could be a leak, a weak vacuum pump or a combination of both. Does it happen more often in fastmix? Feel free to call or txt for help 706-627-7854
Chris Krug http://krugtech.com/
Maximum Up-time, Minimum BS
the laser control signal and the can bus are both common to the byvision cnc rack itself. That's where I would start.
Chris Krug http://krugtech.com/
Maximum Up-time, Minimum BS
Watch the motor shaft on the z axis, does it move smoothly while it's cutting or is it jumping? It's either a sensing issue or the bearings in the z axis
Chris Krug http://krugtech.com/
Maximum Up-time, Minimum BS
I like working on bystronic, I need an independent mitsu tech for a friend w a fiber laser.
thanks
Chris Krug http://krugtech.com/
Maximum Up-time, Minimum BS
did you reset the circuit breaker? it's probably a shorted traswi, transformer or rectifier, possibly one leg of the 3 phase is missing. troubleshooting this is deadly if you don't know the rules. other than that it's simple. first step is inspect hv for arcing and burnt spots. don't let that...
I think you got a stuck key. it could be the extended keyboard too. disconnect the standard keyboard first, ten the machine keyboard, they're hooked up via PS2, USB or serial. hook up a standard usb keyboard via USB to test.
Chris Krug http://krugtech.com/
Maximum Up-time, Minimum BS
Have you considered a waterjet/plasma combo? tcicutting.com makes one and it's getting a lot of attention.
Chris Krug http://krugtech.com/
Maximum Up-time, Minimum BS
I'm with IRstuff, especially the safety aspect. That light is very dangerous compared to CO2.
Chris Krug http://krugtech.com/
Maximum Up-time, Minimum BS
