I found this in Section II Part C SFA-5.1/SFA-5.1M
A6.11.2 Electrodes are manufactured to be within
acceptable moisture limits, consistent with the type of covering
and strength of the weld metal. They are then normally
packaged in a container which has been designed
to provide the degree of...
Where in ASME does it desribe filler metal storage requirments? I know AWS D1.1 describes in details about storage and rod oven temp. requirements therefore I am looking for the same thing in ASME.
I had the stamping done on a header with low stress stamps and the year built is wrong. Should have been 2009 not 2010. Is it ok to sand off the 10 and replace it with 09? I cannot find anything on removal of stamping under ASME section 1.
