Bottom line is: NO! You cannot use the MMC modifier in the tolerance compartment of the feature control frame. When a profile tolerance is applied with no datum references it is solely a form control. The actual size of the feature must be specified in some other manner, which then bounds...
These are certainly good approaches to measurement of that specific total runout requirement (Fig 9-7). Good stuff! Anyway, it really gets to the point made by Jim that a lot of inspectors just don't have the "insight" to be able to figure that out, without some help from a GD&T expert or an...
I agree with all that Jim and Dave said. But I have a bit of trouble with a drawing or perhaps a "figure" that, in itself may be correct, but it may not be very practical. The ASME example (Fig 9-7) is correct and it certainly has an accurate interpretation. But, how practical from a...
