i have attached a diagram to explain may be some body understands it with measurements they are with 5inch
i have 5 truses that need to be cut 5ftx10ft
5ft length of the main cord the cords are 2ft apart so 5 of the will give me...
Thanks to all
I would not cut off any trusess until I have a support for it
the many cord is 24 ft with verticle angled support at 8 ft I have involved a roofing company that claim they have modified roofs such as mine
if I can get drawing as to where and what angle a support is needed then...
thank you very much..just to make it more clear i made a rough diagram hope it makes sense and if you can give me some idea if it is possible.
the centre is 2ft
I should be more clear as to what i on tend to do
1) there is going to be no load what so ever pulling down on the trusses
2) I just want to cut a section out may be 5x10 section, so that when I lift a vehicle up with a 2 poster car lift , the roof of the car goes into the celing of my garage (...
i have 9'7" celling in the garage, where i need to install a hoist,
i need to cut 2 or 3 trusses ,is this possible i would like some advise , there must be a way to support 3 trusses
