Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
CYS - Setup and control
Hello folks, I was wondering if anyone has a way of creating Co-ordinate Systems using a spreadsheet type function to either populate the expression table or create the CYS. So a spreadsheet with a name then an x,y,z column, something like: CYSAA, X=1, Y=2, Z=3, Rotation 0. CYSAB, X=3, Y=2...- DM300
- Thread
- Replies: 1
- Forum: Siemens: UG/NX
-
Bend an extrusion
That's fantastic, had a play with it today you made it look easy. Thankshttp://files.engineering.com/getfile.aspx?folder=8afe3e86-ec0c-499b-87d7-0e0bf0e58089&file=50_Meter_Beam-A_Rolled_(1).jpg- DM300
- Post #12
- Forum: Siemens: UG/NX
-
Bend an extrusion
They vary in sizes, most common would be 200 high, flange width about 125 the bottom flange is thicker then the top. Total lengths change to, 5 to 25 but have gone to 50 meters. The holes that go though the web range in diameters, 20-30ø average. The radius goes through the web centre line in...- DM300
- Post #8
- Forum: Siemens: UG/NX
-
-
Bend an extrusion
Hi all, I have a some parts, long I-beams cross drilled, but the beam itself is on a radius (150metres). To make this the flat beam is put up on a mill and drilled, then run through a press to get the radius. However, if I sweep a section, then put the holes through at the spacing they mill...- DM300
- Thread
- Replies: 11
- Forum: Siemens: UG/NX
