Sir,
I want to buy steam traps . I want to install the steam traps after every 150 feet intervals on drip legs (Dia: 4", Length: 18") at steam mains of 5" and 4" . The pressure in the steam mains is 180 psi~200 psi.
Please recommend me the type and sizes of steam traps so that i may but it...
Hello!
I am new in this field.
I have 22 bar (discharge pressue) Multistage HOT WATER pump ( Temp. of water is 165 C) in the factory. But now i want to upgrade pressure up to 30 Bars. Please tell me the efficient and the most economical way to enhance the pressure? Is installation of other...
Hello!
I have 22 bar (discharge pressue) Multistage HOT WATER pump ( Temp. of water is 165 C) in the factory. But now i want to upgrade pressure up to 30 Bars. Please tell me the efficient and the most economical way to enhance the pressure?
Regards!
well! dubmac! u r quite right. I had performed this method on the the condensate outlet of a tire curing press for measuring the steam flow rate.It gave me better results. But it's not easy for me to use stop watch according to the current situations in the factory :(
Yes! unless I have data...
Well! "SONERGY" Following your suggestion, I have almost done but here another question arises. If i check the current drawn by Motor with the help of an ammeter, do you think that it will help me to predict the efficiency while the motor is designed for 20KW?
Further, how this process will help...
I have a centrifugal pump working on suction lift for cold water at 20 C. its specs are as follows.
Suction dia = 5 inches
Discharge dia = 4 inches
Motor RPM = 1460
Motor Power = 20 kw
Impeller dia = 14 inches
from these specs I calculated head and pressure of the pump as...
Thank you for your reply. I actually want to pump cold water. So will the attached image help me? It shows that the discharge header is vertical. The larger pump discharges straight up into the main discharge header and the other two smaller similar pumps meet the discharge header as shown in...
I have to connect three centrifugal pumps in Parallel.( two of which are of same characteristics while the other one is larger with greater discharge head and capacity).
Now what should the shape of the connections of discharge lines of these three pumps to the discharge header?
