Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
How to apply torque on ellipsetical tube
Sorry for forgetting to mention about the program i have use. I'm using ANSYS V11.- Chomtid
- Post #2
- Forum: Finite Element Analysis (FEA) engineering
-
How to apply torque on ellipsetical tube in ANSYS
Having a hard time in applying torque on ellipsetical tube? I don't know using rigid regions is a correct choice or not. I Have been running this test through the below command for a week. Hope anyone can hepl me. /filename,Ellipsetical tube made of ALUMINUM /title,Aluminum Tube (SHELL99)...- Chomtid
- Thread
- Replies: 2
- Forum: Structural engineering general discussion
-
How to apply torque on ellipsetical tube
Having a hard time in applying torque on ellipsetical tube? I don't know using rigid regions is a correct choice or not. I Have been running this test through the below command for a week. Hope anyone can hepl me. /filename,Ellipsetical tube made of ALUMINUM /title,Aluminum Tube (SHELL99)...- Chomtid
- Thread
- Replies: 3
- Forum: Finite Element Analysis (FEA) engineering
-
how to applying Torque onto ellipsetical tube by using rigid regions
Having a hard time in applying torque on ellipsetical tube? I don't know using rigid regions is a correct choice or not. I Have been running this test through the below command for a week. Hope anyone can take me out of the darkness. /filename,Ellipsetical tube made of ALUMINUM /title,Aluminum...- Chomtid
- Thread
- Replies: 0
- Forum: ANSYS: ANSYS Software Suite
