Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Converting a Solid Works assembly to .sldprt to a .stl
THX I will try that Wade- WAMRod
- Post #4
- Forum: DASSAULT: SOLIDWORKS 3D Design
-
Converting a Solid Works assembly to .sldprt to a .stl
Hey everyone! Thx for the help with my last post! I am still having some difficulty. After I converted my assembly model to a .sldprt I ran into an issue converting it to a .stl so I could run it on Quickcast simulation software. After I save the "model" as a .sldprt I need to convert it to a...- WAMRod
- Thread
- Replies: 4
- Forum: DASSAULT: SOLIDWORKS 3D Design
-
Converting a Solid Works "Assembly" into a "Solid Model"
THX for the tips, I have another question. I am using the simulation software Quikcast. After I save the "model" as a .sldprt I need to convert it to a .stl to run on the simulation software. When I try to convert the model to the .stl it states that my part geometry is not correct to convert...- WAMRod
- Post #10
- Forum: DASSAULT: SOLIDWORKS 3D Design
-
Converting a Solid Works "Assembly" into a "Solid Model"
Hey, Im new to the site so excuse me if I am not following the correct protocol. I just finished my assembly drawing of a full casting, runner, sprue etc. Unfortunately I neglected to realize that in order to run the simulation software I need it to be one solid model. Is there an easy way to...- WAMRod
- Thread
- Replies: 9
- Forum: DASSAULT: SOLIDWORKS 3D Design
