Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. Nessy01

    Converting thread milling cycle to linear output

    Afternoon Chaos I notice a few had asked this question and wondered if anybody had come up with an answer yet? Am conducting ID thread milling trials which need de-tanging and OD thread turning trials which also require de-tanging. So far I have tried (in NX only) 'detailed' and 'symbolic'...
  2. Nessy01

    Probing down deep bore on turn/mill using NX6

    Hi I am trying to probe internal diameter down the inside of a deep bore on a 6 meter bed turn/mill using NX6. I have only been an NX programmer for around a year so could do with a few pointers. Many thanks in advance Ian

Part and Inventory Search

Back
Top Bottom