Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. marcopoloa

    Modelling with a Rubber component

    @WPM3022 Hello there, I was in the same situations for few months until few days ago I came across with the following website. There is a lot of material, lot of plotted stress-strain diagram and the best of it you can download its data for free too! :) https://www.campusplastics.com Good...
  2. marcopoloa

    Riks method

    Hi MRute, The Riks would be a good method for you, just like the dynamic. With the Riks be carefull, because it will not perform very good at Load Control method unless you are using imperfection. The other good stuff for Riks is a Displacement Control method; of course you can use imperfection...
  3. marcopoloa

    apply gravity

    Hi O, You can apply gravity in the Load Module. -->Load,Create,(go down in the menu) Gravity is about in the middle, and put -9810 [mm/sec] into y direction-box, if your gravity is in that way. Click OK, and you applied the G to your whole assembly. Regards, Mark

Part and Inventory Search

Back
Top Bottom