Deal all,
I have a problem with defining contact in large deformation of Abaqus/Standard.
I have two parts which comes to contact with each other and the harder one make scratch on softer one. My goal is to use coarse mesh in softer one and later on remesh it.
But after contacting two parts...
Dear all,
I have two parts in abaqus / standard which are in contact but after applying the force, the other part penetrate the first one without any deformation and I have zero force everywhere(In case of using self contact).
If I use master slave, it will not converge.
Do you have any...
Dear Corus,
These are misses stresses. The values are not important.My goal was just to show that if I use node to surface, the nodes are connected but there is a surface bending between the two nodes. In another words there are gaps between two surfaces at the end of simulation.
And if I use...
Dear Corus,
Thanks for your comment.
I was expecting the same, but it is not.
Please have a look to attached file, then you can see what I mean.
One of them is for node to surface tie constraint and the other one is for surface to surface tie constraint stresses!!
Any idea is appreciated.
Best...
Dear all,
Do you know how can I have continuity in stress or displacement results between parts which are tied together after simulation in Abaqus. I would like to have the same results like merging different parts, partitioning and defining different material properties for it with this...
