Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

1045 Cold Drawn Endurance Limit

Status
Not open for further replies.
Penguineer

Penguineer

Mechanical
May 31, 2012
21
US
Hello All - I have been searching for the endurance limit of 1045 cold-drawn steel bar but have thus far been unsuccessful. Does anyone know where I can search or have a source I could reference to get this value? Thank you.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
I think your best bet will be to use the typical approximation of 1/2 UTS as high cycle fatigue strength. Good Luck otherwise.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

b_unruhly
  • Locked
  • Question
1215 Hot Rolled vs Cold Rolled
Replies
19
Views
35
mfgenggear
mfgenggear
rollingcloud
  • Locked
  • Question
Procurement spec for 304 ss cold worked bar, ~34 - 39 HRC
Replies
11
Views
63
EdStainless
EdStainless
David Maijala
  • Locked
  • Question
Cold forming AL alloy in W or AQ condition 2
Replies
4
Views
31
MagBen
MagBen
Channo
  • Locked
  • Question
Max. Limit to Harden a steel
Replies
13
Views
33
FacEngrPE
FacEngrPE
Laboratorio TRF
  • Locked
  • Question
Out-of-range ultimate tensile strength (UTS) of a cold-drawn 304 tube.
Replies
4
Views
5
Laboratorio TRF
Laboratorio TRF

Part and Inventory Search

Sponsor

Back
Top