Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in

24/48 axle spline standard?

Status
Not open for further replies.
vwdevotee

vwdevotee

Mechanical
Aug 11, 2009
17
0
0
US
I’ve read that all automotive splines are 24/48 pitch in the driveline. Is this based on an SAE standard or a gentlemen’s agreement? If standard, what j report defines that?
 
Status
Not open for further replies.

Similar threads

IWPW
  • Locked
  • Question
Hybrid Spline Rattle 1
Replies
4
Views
17
TugboatEng
TugboatEng
2009JKlover
  • Locked
  • Question
High pinion rear axle with reverse cut gears- design limitations
Replies
1
Views
2
BrianPetersen
BrianPetersen
St0RM33
  • Locked
  • Question
Is there is a proper standard for designing choosing and straight coupling splines?
Replies
14
Views
15
mfgenggear
mfgenggear
Vicky_D
  • Locked
  • Question
Phosphate coating of Hypoid gears of rear axle
Replies
2
Views
8
romke
romke
Shuemb
  • Locked
  • Question
Dana Spicer Slip Yoke Spline Standard
Replies
2
Views
9
DAVIDSTECKER
DAVIDSTECKER
Back
Top