Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

3-D Part from Mesh Possible in Abaqus 6.10?

Thread starter MechIrl
Start date Jul 9, 2010

Status: Not open for further replies.

Jul 9, 2010

MechIrl

Mechanical

I've been waiting a long time for a feature in Abaqus that allows the generation of 3-D geometric parts from orphan mesh parts. I read on another forum that this might be available in Abaqus 6.10. Can anyone on here running 6.10 confirm whether this is the case or not? Maybe it can be done through the new STL handling capabilities?

Would be good to know before I go badgering the I.T guys for an upgrade.