schnell
Electrical
- Apr 26, 2010
- 105
Hello,
this is my step-down converter:
..it is for ...
Vin = 36V
Vout = 5V
Pout = 1.67W Max
SCHEMATIC:
It must go into skip-cycle in light load, hence the comparator.
It has a lot of components, but i see no cheaper way of doing this...since i need a good efficiency in light load, and a controller with low operating current.
I found some Buck IC's but they had high internal FET current limits
and so they would have high "staircase" current at start-up and POTENTIALLY blow the 500mA fuse which lies ahead of the above circuti on the 36V rail.
-Also, the Buck IC's were extremely expensive, and most dod not have pulse-skipping in light load.
by the way here is the LTSpice simulation file:-
do you know of a cheaper way?
this is my step-down converter:
..it is for ...
Vin = 36V
Vout = 5V
Pout = 1.67W Max
SCHEMATIC:
It must go into skip-cycle in light load, hence the comparator.
It has a lot of components, but i see no cheaper way of doing this...since i need a good efficiency in light load, and a controller with low operating current.
I found some Buck IC's but they had high internal FET current limits
and so they would have high "staircase" current at start-up and POTENTIALLY blow the 500mA fuse which lies ahead of the above circuti on the 36V rail.
-Also, the Buck IC's were extremely expensive, and most dod not have pulse-skipping in light load.
by the way here is the LTSpice simulation file:-
do you know of a cheaper way?