3d Mouse in Inventor 2010

[Cwhillvt]

My company just upgraded to Inventor 2010 (I have been using previous versions for many years). 2010 is proving to have a fairly large learning curve but that isn't of concern right now. My question is: where in the options can I set up my 3d mouse? I have found google articles and comments that suggest that some 3d mice did not work properly until 2010 or until a patch for 2010(I'm not totally clear on the issue). I have an old Digital Immersion "Nav3D" mouse. Can anyone comment whether it will even work with 2010?

Thanks in advance

 

[MortenDK]

3Dconnexion runs when you install the driver, maybe the Nav3D is the same? Eventually try update driver etc.

Morten K. Thillemann