Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

3D-Plotting problem

Status
Not open for further replies.

Guest
When i plot my 3D models using hide objects there appear triangels in every surface that's round .
What must i do to have less (or none) triangels in my round surfaces .
 
Replies continue below

Recommended for you

Change the DISPSILH variable from the default value (0) to 1. To do this, just type DISPSILH at the command line, and then change the value.

A related problem I've come across is having curved solids look very faceted. This is changed in a twostep process. First, set FACETRES to 1.0. Then set VIEWRES to 2000 or greater. These two steps must be done togeter, as FACETRES only corresponds to VIEWRES setting if the FACETRES value is 1.0.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor