3D Sketch in hole wizard 1

[m60gunner]

Is there a sure-fire way to NOT get a 3D sketch when creating a hole using the hole wizard? This seems to be the first sketch created when placing the hole. The next sketch (the hole's revolved profile) is a normal 2D sketch.

I would prefer a "standard" sketch as it is easier to define. (I say "standard" even though the 3D sketch seems to be the default).


Air cooled, belt fed, gas operated machine gun firing from the open-bolt position

 

[SBaugh]

Pick the face or surface first, then pick the Hole wizard. If you don't pick the face or surface first, then that is suppose to happen (3Dsketch hole).

Regards,

Scott Baugh, CSWP

http://www.3dvisiontech.com

http://www.scottjbaugh.com

If you are in the SW Forum Check out the FAQ section

To make the Best of Eng-Tips Forums FAQ731-376

 

[m60gunner]

Yeah! Thanks!

Air cooled, belt fed, gas operated machine gun firing from the open-bolt position