3D sketching

[Rick7571]

can you actually sketch in 3D using SE version 18?
I want to protrude wire (not the cable harness type) in 3D

thanks for any help on it

Ricardo

 

[beachcomber]

Hi Rick,
How you do this dependson what you are trying to produce.
If it's bent steel wire such as a CD rack might be made of then you should be able to use use the frames command in an assembly file.
If it's electrical wire you can (in a Part file) use a free-form type curve path using the 'space-curve' or 'cross-curve' commands then sweep your cross-section along the path.

bc.