Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

A 234 WPB

Status
Not open for further replies.
qing2000

qing2000

Industrial
May 7, 2010
1
Hi all,

Please I would like to know if it is possible to manufacture a fitting A234 WPB material from a S275JR plate (material according EN 10025). Is it possible? Is there any special requirement to raw material before manufacturing the final one to A234 WPB?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
You need to obtain a copy of ASTM A 234 and review it.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

MicroEng
  • Question
ASTM A 350 manufacturing
Replies
2
Views
1K
Dhurjati Sen
Dhurjati Sen
KirbyWan
  • Locked
  • Question
Is there a database to go from a materials analysis to a material? 2
Replies
11
Views
1K
ShataCastings
ShataCastings
wontweldcantweld
  • Locked
  • Question
ASME IX - Can a lower SMYS cover a higher SYMS?
Replies
0
Views
142
wontweldcantweld
wontweldcantweld
rollingcloud
  • Locked
  • Question
How much hardness change can I expect from a low-level stress relief on a 17-4 SS part?
Replies
13
Views
440
EdStainless
EdStainless
IngeniousQuest
  • Locked
  • Question
Failure analysis of a thin-walled tube
2
Replies
26
Views
768
mfgenggear
mfgenggear

Part and Inventory Search

Sponsor

Back
Top Bottom