potrero
Mechanical
- Aug 30, 2007
- 516
NX7.5 windows 7 64 bit (happens on 7.5.3 and 7.5.4)
Sometimes when loading assemblies we get the following error:
Could not open (part)
The following files could not be loaded
causing this open to fail:
(part) - A tag was passed belonging to an object that could not be found
If this error pops up, the assembly will fail loading and NX reverts back to the File>Open dialogue.
So far I haven't been able to trace this to any specific cause. Sometimes, loading "Structure Only", then individually loading the components, allows the assembly to load, but this is obviously a pain.
Has anyone else encountered such an error, and been able to pinpoint its cause? What's the solution, or how to avoid?
Sometimes when loading assemblies we get the following error:
Could not open (part)
The following files could not be loaded
causing this open to fail:
(part) - A tag was passed belonging to an object that could not be found
If this error pops up, the assembly will fail loading and NX reverts back to the File>Open dialogue.
So far I haven't been able to trace this to any specific cause. Sometimes, loading "Structure Only", then individually loading the components, allows the assembly to load, but this is obviously a pain.
Has anyone else encountered such an error, and been able to pinpoint its cause? What's the solution, or how to avoid?
