I am making a threaded insert to repair an A126 casting.
The insert will be threaded into the casting and then pinned axially at the edge to prevent it from rotating out. I will use LOCTITE to remove as much of the space from the insert threads and to protect (somewhat) from galvanic corrosion. With this chemistry, A126, what could be used as a suitable insert material and not interact much with the casting material?
I want to avoid any galvanic corrosion because this area will not be visible.
Base material is gray cast iron, A126
Thanks,
AWOL
The insert will be threaded into the casting and then pinned axially at the edge to prevent it from rotating out. I will use LOCTITE to remove as much of the space from the insert threads and to protect (somewhat) from galvanic corrosion. With this chemistry, A126, what could be used as a suitable insert material and not interact much with the casting material?
I want to avoid any galvanic corrosion because this area will not be visible.
Base material is gray cast iron, A126
Thanks,
AWOL
